625i quit running Saturday it will turn over no indication to fire, replace fuel filter, Fuel pump pumping fuel , sprayed seafoam in intake will run until seafoam is exhausted any ideas

SOURCE: Daewoo Lanos, turns over but will not start.......

dave again i just posted you so it is definately fuel related listen to see if the fuel pump turns as described in my last post if it does not you can test the relay by replacing it with a known good relay like the horn if your horn works but your fuel pump does not turn swap em see if the horn works still and if the pump now works. If the pump works and the horn does not reinstal the horn relay in its original position and replace fuel pump relay. do the same with fuel pump fuse as sometimes the fuse looks okay but is not. If you have a test light hook it to ground and make sure both metal tabs on the fuse light the light when the pump is activaed.

SOURCE: 2000 chevy silverado 1500 4.3 eng

Chevy Trucks, Blazers, S10 pickup and the like will vapor lock ecspecially the 2000 models. Do not tighten the gas cap past 1 click. There is a tube that runs from the top of the tank down and this gets hot and collapses or burns in half. We just bought a reinforced rubber tube cut it to lengh and use it instead of part and it's worked grat for 2 years so far.

SOURCE: 1991 camaro RS Fuel pump not working- no power to pump

If the oil pressure switch has two wires on it it may be one that shuts down the pump. I'm not positive but I think it completes a ground circuit, not the hot side though (but may run through a relay.) There should be a pump relay under the hood with a group of other relays. I don't have a wiring diagram for your car but you can get a basic diagram in most inexpensive manuals. They wont usually give you locations but at least you can get an idea of how the system works. There usually is a fuse. If the fuse block is not labeled, use a test light and probe the back of every fuse for power with the key on (takes about ten minutes and faster than trying to find info) change any that are blown. The most likely culprit is a relay, so after testing fuses look for it. (usually on drivers fender or on right side near firewall.) Worst case, trace the power lead all the way through the harness 'till you find where power begins.Testing is important here...I could give you much better info if I was there to do it for you. Most important is to stay "on track" till you find the place where power ends. Don't jump all over the place or you will end up doing an incomplete test.

SOURCE: 1986 BMW 318i;Turns over but engine wont run.I'm

have you tried the fuel regulator

SOURCE: How do you replace the fuel pump in 1992 2wd Subaru Legacy Wagon

How about just rolling up carpet behind seat and accessing fuel pump cover. unscrew cover sc.rews, disconnect plug and hose clamps use 8mm socket to pull bolts. Much easier than pulling gas tank