Cars & Trucks - Answered Questions & Fixed Issues
Chrysler Sebring 2008 convertible top malfunction message
As long as the trunk is open, It won't work. The top has it's own computer. Have the codes read. Takes a scanner. These have like 20 sensors and switches for the top and trunk. You can try to close the latch on the trunk with a screwdriver to get it to work. Another thing is there is a cover that pulls out . This has to be pulled out and latched in place. This will keep it from working also.
2007 Buick Lacrosse. Where is the engine coolant temp sensor located on it please?
which engine, post VIN and we tell you.or tell dealer parts page you vin and like magic it tells you what engine is there,most times this sensor is next to the thermostat housingbut not all times.( like reverse flow rad/engine)wiki same name see 2.4 L LE5 I4 (China) 3.0 L LZD V6 (China) 3.6 L LY7 V6 3.8 L L26 V6 5.3 L LS4 V8 hark
4/18/2024 10:42:45 PM •
2007 Buick...
•
Answered
Yesterday
•
34 views
Start up g6 gt 2007 whining noise
You need to determine where the noise is coming from. Check your power steering fluid and make sure it is full. Remove your serpentine belt and see if the noise goes away, That will let you know if it is coming from the engine or an accessory or pulley bearing. If the noise goes away whith the belt removed, check the alternator bearing and pulley bearings. If the noise is still there whith the belt removed, that means it is either in the engine or transmission.
4/18/2024 10:09:44 PM •
Cars & Trucks
•
Answered
Yesterday
•
16 views
Why is there no power to brake lite switch
what car, year,maker ,model
power to switches are fuse blown.
on old cars.
then 2007 to 2010
there is no fuse the BCM body brain runs brake lamps direct
and a small voltage digital signal from the switch
totally differ ways on new cars
is this a trail lamp issue?
tell car and I will show you the brake schematic from the online
FSM book.
4/18/2024 9:59:17 PM •
Cars & Trucks
•
Answered
Yesterday
•
16 views
2007 Buick Lucerne no crank no start key won't release won't come out of the park won't read that is in park
Here are some possibilities you can test yourself. But if none of them resolve your issue, you may need to consult a professional mechanic. Jeff Armer seems to have supplied even more detail. Just how comfortable you are will such procedures may determine just when you choose to go to a professional mechanic.
No Crank or Start: This could be due to a weak battery, corrosion on battery terminals, poor starter electrical connection, bad ground connection, or a faulty starter motor. You might want to check the wires to the starter. If the car starts and runs when you jump the starter from underneath, it could indicate an issue with the starter circuit.
Key Won't Release: First, ensure your vehicle is in Park and that the steering wheel is not locked. If the key still doesn't turn, try using a spare key, as the original might be worn-out or bent. If the problem persists, you might need to consult a mechanic or replace the ignition switch.
Another method to try is to turn the key to the start position, let it fall back to the run position and leave it sit for ten minutes. Cycle the key off and wait five seconds and it should start. The battery has to be fully charged for this to work.
Won't Come Out of Park or Won't Read That It's in Park: This could be related to the vehicle's security system. Running a diagnostic check for codes with a scan tool of both the Powertrain control module/ecu and the Body control module could help identify if any codes are stored. The vehicle should crank over in park or neutral.
Were is the horn located on my 2017 citroen dispatch
The most likely location for it is up under the front, left wing between the front wheel and the bumper. You might need to take the wheel arch liner out to get to it. If it's not there check the wheel arch on the other side. Another common location is behind the front bumper mounted on the bodywork crossbar between the radiator and the front grille.
Not finding what you are looking for?