Washer,will not stay level? - Washing Machines

Make sure the sensor wire is connected and/or not broken

With the washer off, unplug it and plug it back in the lights should blink twice. Then press the wash temp and water level keypads at the same time. The water level should stay on but all others should stay off. If this happens the washer is in diagnostic test mode. Hope this helps

low oil pressure switch faulty or oil level low, disconnect pressure switch then try.

Possible there is level fault in the floor setting. You can use a simple spirit level and adjust the level of the washer with a tilt to the rear for easy drain. Also check for bearing fault if there is wobbling, check for counter weight or alignment fault of the drum if the frames are rusted.

Likely the feet to the dryer are not level. Grab a large level and check to ensure the top front is level across.

If your door opens to the right, raise the front left foot by screwing it counterclockwise. Check level, and repeat.

Mirror the operation for a door that swings to the left.

Either the resivoir is low of fluid or the sensor is stuck down or defective. Inspect the fluid level sensor.

the ser soon light is a maint thing and can be reset if all maintance has be done the other symbol could be low coolant or low washer fluid check all your fluid levels frist.

Check your shocks that holds your tub up on the inside.

check to see if the shocks are broken, 4 of them. A service guy fixed mine with new ones

YOUR REAR LEVELING MECHANISM IS SELF LEVELING FROM SIDE TO SIDE YOUR FRONT FEET ARE INDIVIDUAL MAKE SURE THE REAR OPERATES PROPERLY AND RELEVEL THE MACHINE IN BOTH DIRCTIONS. EACH TIME YOU MAKE AN ADJUSTMENT TO THE FRONT FEET WETHER IT BE THE RIGHT OR THE LEFT RE-RAISE THE REAR SO THAT THE REAR ADJUSTMENT WILL AUTOMATICALLY SET ITSELF TO WHAT YOU HAVE CHANGED ON THE FRONT FEET. YOU MAY HAVE TO DO THIS REPEATEDLY TO GET THE BEST POSSIBLE LEVELNESS IN BOTH DIRECTIONS. ONCE YOU ARE SATISFIED THE FRONT FEET SHOULD HAVE A SET NUT RUN THIS NUT UP TIGHT TO THE BASE OF THE WASHER.