The soap tablet is no longer fully dissolving in its compartment, still does so when placed directly in d/w but finish is not as good

If the dishwasher is undergoing short programmes and low-temperature washes then your dishwasher may not allow for the tablet to fully dissolve leaving some remaining tablet left behind. Another reason why the tablet may not be dissolving is because of the water hardness of the area you live in as the tablet may take longer to dissolve in the water.

Is the dishwasher heating ? , check heating element / pcb

Is the water coming on? Is water hot enough? Is washer overloaded, water jets aren't hitting the soap? Maybe try a different brand of soap tablet? Run the dishwasher in "heavy soil" mode which will use hotter water and run for longer?

sometimes the dispenser doors are not designed for tablets, and they don't let enough water in to dissolve them....next time you wash; put the tablet in one of the silverware compartments....should do the trick. and leave the dispenser door for liquid detergents only.

if this is helpful please click the correct button. thanks

I believe that the instructions for using these 3-in-1 tablets is to place it in the open dish detergent cup, rather than in the closable compartment, since the tablet needs to get doused by a lot of water in oder to fully dissolve and be effective in getting the dishes clean.

Since the tablets are designed to dissolve more slowly, they are able to be used for the entire range of washing cycles. If it's a constant problem and you don's have an open detergent cup below or next to your closed detergent dispenser, just toss it into the bottom of the dishwasher instead.

The reason that the tablet isn't getting dissolved fully is because the door is preventing the tablet from dropping all the way out and the door is shielding the tablet from quite a bit of water spray.

Another option is to take a look at your owners manual for the dishwasher and see if they recommend these all-in-one tablets versus regular powered detergent and liquid rinse aid.

Hope that helps and best regards!

check the four things
1. run faucet to increase temp going to machine.
2.add jet dry liquid in compartment. fill then shut door and lower then raise the door,3times this will take the air out of the dispenser compaRTMENT. then refill somemore repeat steps until nomore can go in.
3. add the soap cascade is good. after that start the machine and thank me with a 4 thumbs up post. thanks!

I don't have a solution, but the exact same problem is happening with my dishwasher. Nothing is getting cleaned properly.

Did you manage to get the problem fixed?

Try reversing the bottom dish rack, it's likely blocking the dispenser door because it's put in the dishwasher incorrectly. Also check if there is anything in the back of the rack preventing it from going all the way in.

Hi!

Please run the machine without detergent for 2-3 washes. Also try using a little hot water. Also, don't used cleaner and softener together but add softener on the last rinse.

Sounds like whatever soap you are using is just too much soap your dishwsher can handle. The soap "packs" are usulally an overload of soap for most dishwashers. Just a few teaspoons of regular name brand soap sometimes will cure lots of dishwsher ills!!!