20 Most Recent
2012 Piaggio Fly 50 4V Questions & Answers
Why won't my lights work
It sounds like your alternator is not charging the battery. Fit a new battery remember to undo negative lead first to remove and fit positive lead first to refit the battery. When the new battery is filled please charge it using less than 1 Amp DO NOT use a car charger or try to jump start it. Your new battery should show 12.5 to 13 volts on a meter for a 12 volt system and 6.3 to near 7 volts for a 6 volt system. Start the scooter and check across the battery terminals your meter should show about 14.4 V for 12 volt battery and about 7.5 V for a 6 Volt one. No voltage increase means your charging circuit is not working. Either the alternator or rectifier(regulator) are not operating correctly. Worst case scenario is both units dead.
Why won't my lights work?
Have you checked the wiring to the lights. Sounds like you have a wire that has shorted to ground. Would also explain your battery drain. I'd check the wiring before the ignition switch since it is draining your battery with the switch in the off position.
Piaggio fly 50 4t
Re-set the idle adjustment screw on carb? Also check fuel / air filter.
Not finding what you are looking for?